Material Safety Data Sheet                                                     January 2, 2007

Product Identification  NISSEN LOW CHLORIDE FELTIP PAINT MARKER - WHITE

 

J.P. Nissen Co.                         Phone: 215-886-2025

2544 Fairhill Avenue                            Fax: 215-886-0707

P.O. Box 339                                        Emergency: 1-800-424-9300

Glenside, PA 19038

 

HMIS Ratings-Health 1 Flammability 3 Reactivity 1

NFPA Ratings- Health 1 Flammability 3 Reactivity 0

 

Hazardous ingredients – The paint is contained in a valve action reservoir and will not leak under normal conditions.

 

Ingredients                              CAS#                            %                      Exposure Limits

Mineral Spirits                        64742-88-7                    30-35                  100 ppm/8 hrs pel

VM& P Naptha                        64742-89-8                      15-20                  300 ppm/8 hrs pel

Xylol (Xylene)                         1330-20-7                         1-5                     100 ppm/8 hrs pel

Titanium Dioxide                    13463-67-7                    15-20                  5 mg/cu.m Respirable dust

High Boiling point

Aliphatic Hydrocarbon           64742-47-8                         1-5                   100 ppm/8hrs pel

Physical Data

Boiling point:246-404 F            Vapor density: Heavier than air.

Volatile %: 66.7% by volume      Specific gravity: Less than 1.

Evaporation rate: Slower than Ethyl Ether     Vapor Pressure: 6.2 mm hg @ 20 deg. C

Appearance: White viscous liquid with an aromatic odor.

Volatile Organic Compound data not required because product only produced in quantities of less than 1 liter

Fire and Explosion Data

Flammability Class: IC Flashpoint: 75 deg..F  LEL:1%  UEL 7%

Extinguishing Media:   Foam, Carbon dioxide, or any Class B extinguishing agent.  Water may be unsuitable as an extinguishing medium, but helpful in keeping adjacent containers cool.

Health Hazard Data

Listed as possible carcinogen: NTP – No IARC – OSHA – No

Symptoms of over exposure: Headache, Dizziness, Nausea, Coughing, Eye, Throat and Skin Irritation.

Effects of overexposure: Slight to severe irritation to eyes and mucous membranes.  Dermatitis.                               Affects central nervous system.

Emergency first aid: Inhalation; seek fresh air.  Give artificial respiration if not breathing.

Skin contact; Wash with soap and water.  Ingestion; Call Physician. Do not induce vomiting. If vomiting occurs, keep head below hips to prevent aspiration of liquid into lungs   

Reactivity Data

Stability: Stable,  hazardous polymerization: Will not occur.

Conditions to avoid: Heat, open flames and sparks.

Incompatibility: Do not expose to strong oxidizers.

Hazardous decomposition products: Carbon monoxide, carbon dioxide.

Environmental Protection Procedures

Remove all sources of ignition, ventilate area, and use absorbent material to clean spills.

Disposal method: Dispose of waste in accordance with all local, state and federal regulations.

Control Measures

Respiratory protection: None required under normal use.

Ventilation: Normal-working conditions.

Protective Equipment: Safety glasses and gloves. No special clothing required under normal

conditions of use.                      

Transportation

Shipping Class ORM-D

UN Number 1263

Package Group III

Toxic Substances Control Act TSCA states:

All components of this product are listed in the EPA’s Inventory of Chemical Substances as required under the Toxic Substances Control Act (TSCA)

California Proposition 65 (Chemicals known to cause cancer)